naf I finally had some luck logging in. I found from another source what the admin password might be (qwe!@#123) and I tried it and it worked. I then changed the admin password to what I wanted and I logged in with my password. I then rebooted and sucessfully logged back in with my password. I then found out what the firmware version was (3.1.2.5897) and proceeded to successfully update the firmware to OBi2xx-3-2-2-8680EX-arrynrob13. I rebooted again and I successfully logged back in with my password.
Now comes the bad luck part. I was curious if the settings and password would be the same after a hard reset and nope. I had to re-enter the same IP address I had given to it earlier before I did the reset so I could log back in. The admin password had reverted back to the original password, qwe!@#123, and the provisioning parameters had also reverted back to what they were in the beginning.
Provisioning details stated it was a dialpad provisioned unit.
I would have thought that after updating the firmware all of the OBItalk related options and provisioning parameters would have been removed.
I guess this unit is SOL.
From my searching on the web about the DeviceInfo.ProtectFactoryReset parameter, sounds like I’m out of luck.
The DeviceInfo.ProtectFactoryReset parameter on the Poly OBi300 controls whether a factory reset clears all configuration settings or is restricted. Setting this parameter to 1 limits the reset to parameters with user read-write permissions only, protecting hidden or read-only settings from being reverted to defaults. Setting it to 0 allows a full reset of all parameters, regardless of their user permission status.
This parameter can only be modified via remote provisioning, not through the local web interface or IVR. Service providers use this setting to prevent users from accidentally or intentionally removing critical configuration parameters that might hinder normal device operation. When a factory reset is performed (via IVR code ***/8 or the hardware reset button), the device’s behavior depends on this setting and the DeviceInfo.FactoryResetMode parameter.