Actiontec/Screenbeam WCB6200Q Open Source Attempt

jweaver

Apologies in advance, if this is not the best place to post this. Does anyone have the WCB6200Q (preferably the regular consumer version) and went the open source route and customized the source code a bit and have installed it onto it?

For instance, the pre-built firmware provided by Actiontec is (1.1.10.20re) but when viewing their open source page, the latest possible available is 1.2L.03.5.

Basically, I was hoping to be able to download that 1.2L version compile it as is to build the installable image to install it onto my WCB6200q. Not looking to actually alter any of the source code, but maybe just altering the GUI a bit at some point. I have not been getting any luck at getting it to compile.

real_aurgathor

Maybe you could post some relevant links,

I have an older (probably around 10 years old or so ) screenbeam, though I haven;t used it at all after the first year, so I’m not sure if any of the above would be applicable.

jweaver

real_aurgathor Apologies that I have not seen this until now.

https://opensource.screenbeam.com/wcb6200x.html

Basically all I have is the 1.2L.03.5_consumer image plus both the compiler toolchains, but not sure what to do with it further. All I want to do at the moment, is at least compile that one as is, if it will allow a NCS compile just to see it run, maybe after then I’d edit some of the html to unhide certain pages, maybe some page redesigns, etc.